id: 3.2-airport-properties title: 3.2 Airport Properties meta: Learn how to change airport properties within the Scenery Editor of Infinite Flight. order: 2 #

3.2 Airport Properties #

3.2.1 #

To edit airport properties the below steps must{.red} be followed:

Step 1

: Tap “File > Airport Properties” (1) from the management buttons on the left of the screen

Step 2

: The airport properties will appear on the right hand side of the screen (2)

Step 3

: All are adjusted by tapping the property, except for “Frequencies” (see 3.2.3 below) and then entering the new value/name and tapping “OK”

Step 4

: Some of the properties may already be populated, Editors must{.red} ensure that these are correct and fill in any properties that are missing

Image 3.2.1.1 - Airport Properties

3.2.2 #

Airport Property Purpose
ICAO Four letter ICAO code (e.g. KSFO or EGLL)
Elevation Elevation of the airport
Name Name of the airport
Spoken Name Name of the airport that will be spoken in-app
City City that the airport is located in (or nearest to)
Country Country that the airport is located in
State State or equivalent (such as county) that the airport is located in
IATA Code Three letter IATA code (e.g. SFO or LHR)
FAA Code Three to five letter alphanumeric code for airports in the USA only (usually similar to the IATA code)
Airport Class Class of airport (from Alpha to Echo)
Latitude Latitude of the airport (this should not{.red} be changed)
Longitude Longitude of the airport (this should not{.red} be changed)
Frequencies The frequencies of the airport
Taxiway Routes Available When selected, orange tick is displayed (must{.red} be selected for ATC taxiway network to be available to controllers and pilots)
Jet Bridges Available When selected, orange tick is displayed (must{.red} be selected for animated jet bridges to be available to pilots but only once jet bridges have been added and are usable - see 10.4.1 below)

3.2.3 #

To add/delete or edit frequencies, the below steps must{.red} be followed:

Step 1

: Tap the “+” symbol next to “Frequencies” (1)

Step 2

: All frequencies currently listed for that airport will appear beneath. Tap the “+” symbol to the left of a frequency to open its properties (2)

Step 3

: Frequency Type, Name, Frequency and Spoken Name can all be changed in the same way as other airport properties (see 3.2.1 above)

Step 4

: Tap the “-” symbol to the left of the same frequency to “close” its properties tab (3)

Step 5

: To delete a frequency, tap the “-” symbol on the right of that frequency (4)

Step 6

: To add a new frequency, tap the “+” symbol at the bottom right beneath all frequencies (5)

Image 3.2.3.1 - Editing Frequencies